Xerox Versant 80 Press, Руководство пользователя

Страница: 356 / 382

Trimmer Options
When using the Trimmer options, always consider the following:
• Booklets exiting the SquareFold Trimmer Module may contain trim remnants or scraps
from the previously trimmed booklet. This may be due to static electricity build-up
and is normal. If booklets contain trim remnants, simply remove and discard them.
• The Trimmer feature can be switched on or off. When the feature is on, you can
adjust the trim setting in 0.1mm / 0.0039 inch increments depending on your
requirements for the finished booklet job.
The Trimmer options include the following:
• Trimming On / Off: Switch On / Off the Trimming feature. The default setting is Off.
• Cut to Size: Use the Left / Right Arrow buttons to decrease or increase the trimmer
setting. Adjustments are made in 0.1 mm / 0.0039 inch increments.
The trimmer setting is based on the following items:
• The number of sheets in the finished booklet
• The finished booklet width size
• The media type (coated or uncoated)
• The media weight
Note
Experiment with various settings to determine the best selections for your job. You may
want to run one or more test prints before running larger jobs for best booklet output.
Note
Trim settings cannot be adjusted to remove less than 2 mm (0.078 in.) or more than 20
mm (0.787 in.) of edge material from the booklet. Adjustments less than 2 mm may
produce poor trim quality. Adjustments greater than 20 mm result in no trimming to
the booklet edge.
Trim Guidelines
The following table shows various scenarios using different paper weights, media types,
and trim setting selections. Use this table as a guideline when selecting a trim setting
for your specific job.
Note
The settings shown in the following table are provided as examples and are not meant
to represent every possible job scenario; again, use this table as a guideline only.
Xerox ® Versant ® 80 Press 25-6
User Guide
SquareFold Trimmer Module