Xerox Telecopier 7033, Руководство по обслуживанию

Страница: 230 / 286

1.5 Installation
1.5.1 Auxiliary Tray Assembly
1. Remove auxiliary tray assembly from carton and verify contents.
•
auxiliary tray assembly • right side cover
• paper guide • hardware (in bag)
2. On the terminal, remove the following:
a. both output trays and the paper tray
b. right side cover (REP 4.1.2)
c. metal end plate located under the right side cover
d. rear cover (REP 4.1.7)
3. Set the terminal on its left side and remove both operator guide
holders.
4. On the auxiliary tray assembly, remove the paper tray and the rear
cover.
5. Insert (do not tighten) the three rear mounting screws on the
auxiliary tray assembly (Figure 1). Leave the screws loose enough
for the brackets on the terminal to slide through.
Figure 1. Auxiliary tray installation, rear screws
a a a a a a a a a a a
a a a a a a a a a a a
a a a a a a a a a a a
a a a a a a a a a a a
a a a a a a a a a a a
a a a a a a a a a a a
a a a a a a a a a a a
Machine
Front
a a a a a a a a a a a a
a a a a a a a a a a a a
a a a a a a a a a a a a
a a a a a a a a a a a a
a a a a a a a a a a a a
a a a a a a a a a a a a
a a a a a a a a a a a a
Machine
Top
7033-278
Auxiliary tray
wire harness
Auxiliary tray
6. Join the auxiliary tray assembly to the terminal. Secure the front
with three screws, and tighten the three rear screws (Figure 2).
7. Perform the following:
a. Install the operator guide holders on the bottom of the
auxiliary tray assembly.
b. Connect P/J194 at the bottom of the electrical box.
c. Install the drive belt on the paper input roller gear (Figure 3).
NOTE: If there is excessive slack in the drive belt after installing
the belt on the gear, loosen the auxiliary tray mounting screws
and bias the tray unit away from the terminal to remove the
slack. Do not over tighten belt. 1/8 inch travel is normal.
Retighten the screws.
6/92
Telecopier 7032 / 7033 Service Manual 8a-6
1.5.1
www.printcopy.info
www.printcopy.info