Configuring SNMP
System Administrator Guide
4-15
Configuring SNMP v1/v2c
Configuring SNMP v1/v2c Community Names
To configure SNMP v1v2c community names:
1.
Launch your web browser.
2.
Enter the printer’s IP address in the browser’s
Address
field (http://xxx.xxx.xxx.xxx).
3.
Click
Properties
.
4.
Select the
Protocols
folder on the left sidebar.
5.
Select
SNMP
.
6.
If prompted, enter your Admin or Key User name and password.
7.
On the
SNMP Configuration
page, click the
Configure SNMP v1/v2c
button.
8.
To set community names for GET/SET SNMP queries and traps, enter information (up to
32 alphanumeric characters) in one or more of the following fields:
Note:
These names are not displayed on this page, but are shown as a row of asterisks (*).
■
GET Community Name
: Allows a host to perform SNMP GETS on the printer using
this community name.
■
SET Community Name
: Allows a host to perform SNMP SETS on the printer using
this community name.
■
Trap Community Name
: Allows a host to receive traps from the printer using this
community name.
Note:
Hosts must have these community names configured in their applications to access
the printer using
SNMP v1/v2c
.
9.
Click the
Apply
button to save the changes.
10.
If prompted, enter your Admin or Key User name and password.
Adding or Editing Traps for SNMP v1/v2c
To add or edit traps for SNMP v1v2c:
1.
On the
SNMP Configuration: Configure SNMP v1v2c
page, click the
Configure Traps
button.
The
SNMP Configuration: Configure Traps
page lists the current Trap Destination
Addresses
for the SNMP protocol.
■
The
Address
column lists the Trap Destination IP address or DNS Name.
■
The
Version/Type
column lists the SNMP Trap version or Inform Request for sending
to the specified trap address. SNMP Trap versions include SNMP v1 Traps, SNMP
v2c Traps, and SNMP v2c Inform Requests.
■
The
Traps
column lists the types of traps to send to the Trap Destination Address.
Traps to be received include Printer Traps, Job Monitoring Traps, Cold Start, and
Authentication Traps.
