Xerox DocuPrint 96, Руководство оператора

Страница: 76 / 548

PAPER FACTS
2-8 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS OPERATOR GUIDE
Feeder trays
Your LPS provides three feeder trays:
•
Two processor feeder trays
•
One high-capacity feeder (HCF) tray.
Up to three different stocks may be used within a print job, including
oversize covers or tabs.
Note: If your LPS is fitted with a bulk feeder, the number of
available stocks increases by one.
For instructions on selecting feeder trays and managing clusters
(groupings of trays), refer to the “Status and print tasks” chapter.
Feeder tray features
Note the following features of the feeder trays:
•
Any tray not currently in use can be opened, pulled out, and
loaded, without interrupting printing.
•
If you try to open a tray currently in use, feeding switches to a
backup tray if one is available. If one is not available, the printer
stops.
•
The printer does not feed all the paper out of a tray. (A stack of
approximately 1/4 inch/6 mm remains in the tray.)
Loading a feeder tray
To load one of the feeder trays.
Step 1. Select the tray you want to load by pressing the Tray Unlock button
on the paper tray. The Tray Unlock button is shown in figure 2-1. You
may also select the tray through the printer mimic on the printer
control console. Refer to the “Lower trays and bins” section of the
“Status and print tasks” chapter for instructions.
Note: If the printer has stopped due to a low paper condition,
you do not need to press the Tray Unlock button.
Figure 2-1. Tray Unlock button