Xerox DocuPrint 92C IPS, Руководство по устранению неисправностей

Страница: 43 / 49

XEROX DOCUPRINT 92C IPS TROUBLESHOOTING GUIDE 4-1
4. 4 System unresponsive
This chapter describes problems in which your monitor shows no
image, the printer does not respond when you press the Continue
button, or the IPS main window does not respond.
Symptom Probable cause Action
Blank display: pressing a key
fails to restore image. Monitor is switched off;
brightness and contrast
controls are misadjusted; or
there is a more serious
problem. 1. Make sure that the monitor is switched
on.
2. Make sure that the brightness and
contrast controls (if available) are turned
far enough to the left to brighten the
screen.
3. If switch is on and controls are turned to
the left, call the service representative.
You have cleared all faults that
are listed on the printer control
console, but the Attention light
is still on and the following
message is displayed:
Output is stopped. See
message at the System
Display
There is an uncleared output
fault. Follow the instructions in the output message
and press the Continue button.
Printer main window does not
respond (lockout). Someone accessed the
System Meter Readings
display from the System
Options menu while the printer
cable was disconnected. Call for service. Tell the representative if the
printer cable is connected to the printer and the
Printer Controller.
Caution: Do not attempt to reconnect the
cable yourself.
Printer console displays the
message:
Press continue to
resume printing
,
but the printer does not
respond to the Continue
button.
An internal error has occurred. 1. Be sure you have pressed the Continue
button on the printer , instead of clicking
the button on the screen.
2. Power the printer off and on to reset the
printer.
3. Reboot the Sun workstation.
Caution: Do not power off the Sun workstation
to reboot it. Use the rebooting procedure
described in the
Xerox DocuPrint 92C IPS
Guide to Configuring and Managing the
System
.