Xerox CSX 2000, Руководство по установке

Страница: 225 / 266

Adding an External Device 215
3.
If the CSX2000 Color Server does not have Tag Matrix #4, order
the following parts: Flat cable 68 Mini D-Type X3 Plg (Cable –
SCSI Disks; System) p/n
117N01567,
Terminator 68 MLVD/ single
end W p/n 115N00355.
Next, perform the following:
•
Remove the front panel (refer to the CSX2000 Color Server
Technical Guide for details).
• Remove the right outer side cover (refer to the CSX2000 Color
Server Technical Guide for details).
• Remove the side support bar (refer to the refer to the CSX2000
Color Server Technical Guide for details).
•
Disconnect the internal SCSI cable from the CPU, VPM,
System disk and remove it from the system.
• Remove the metal cover from I3 using a screw driver and a
hammer, insert the new SCSI cable and connect it to the CPU,
System disk. Connect the metal connector to I3 using the
supplied screws.
See the following graphic.
• Return the side support bar, the right outer side cover and the
front panel.
The configuration of the unit has been changed to Tag Matrix #4.
Mark off Tag Matrix #4 on the CSX2000 Color Server.
4. Connect the external SCSI cable to the SCSI external outlet (see
the above drawing) and to the external device.
5. Connect the device to the external SCSI connector on the
CSX2000 Color Server, and verify that the device is defined as
ID1 or higher.
6. Turn the external device power on.
The terminator will be required If the external device is disconnected. In this
case, the terminator will be connected instead.
When the external device is disconnected, connect the external termination
to the external SCSI connector.