Configuring SNMP
System Administrator Guide
4-19
The Any User/Driver Account Settings
■
User Name
: Displays
anyuser
by default and cannot be changed.
■
MIB Access
: Displays the Any User account’s MIB access permissions selected on the
Configure SNMP v3: Other Account Settings
page. This can be set to
Read
or
Read/Write
.
■
SNMP Read
: Displays a check symbol if SNMP Read access is enabled. SNMP Read
access can be enabled for the Any User account after the Key User account is created.
■
SNMP Write
: Displays a check symbol if SNMP Write access is enabled. SNMP Write
access can be enabled for the Any User account after the Key User account is created.
■
Driver Account Enabled
: Displays a check symbol if the
Driver Account
is enabled
(default).
Note:
If the
Driver Account
is disabled, it breaks communication between the printer and
any applications using SNMP v3, such as Xerox printer drivers and PrintingScout. For a
complete list of applications disabled, see
Disabling SNMP
on page 4-20.
Configuring the SNMP Access Control List
To set up a list of hosts that are authorized to access the printer using SNMP:
1.
Launch your web browser.
2.
Enter your printer’s IP address in the browser’s
Address
field (http://xxx.xxx.xxx.xxx).
3.
Click
Properties
.
4.
Select the
Protocol
folder on the left sidebar.
5.
Select
SNMP
.
6.
If prompted, enter your Admin or Key User name and password.
7.
Enter up to ten host IP addresses in the
SNMP Access Control List
field. Separate entries
with a blank or a comma, specify ranges with a hypen (-), and use an asterisk (*) to
represent a group of numbers (e.g., 13.62.156.*).
8.
Click the
Save Changes
button.
See also:
About Access Control Lists
on page 4-4
