Xeos Technologies Inc. Alert Geomatics Xi-100b, Руководство пользователя, Страница: 14 / 33

Xi-100b User Manual Version 4.1 14
Timer Description
Ver Xi-100b Firmware version
Uptime Time (DD:MM:SS) since last power-up or reset
Vb Supply voltage currently read by the Xi-100b
Temp Shows current temperature read by the Xi-100b (Celsius)
Q330 Shows if Q330 functionality is enabled/disabled (Y/N)
Heater Shows if heater functionality is enabled/disabled (Y/N), shows temperature
heater needs to reach to shut off if turned on
Sensor Shows if external sensor functionality is enabled/disabled (Y/N)
Rudics Shows if RUDICS functionality is enabled/disabled (Y/N), routing (Serial/Ethernet),
RUDICS Mode (Off, Single, Continuous), Continuous minutes, Cool-down period
Dial# RUDICS number dialed to establish RUDICS connection
Ethernet Shows if Ethernet is enabled/disabled (Y/N) for interface with peripheral device
Badpg
Number of bad flash pages in memory
IP IP address set in the Xi-100b
Mask Subnet mask set in the Xi-100b
DefRtr Gateway IP set in the Xi-100b
Mo24 Mobile-originating messages, last 24 hours. Number of messages sent by the Xi-
100b in the last day.
Mt24 Mobile-terminating messages, last 24 hours. Number of messages received by the
Xi-100b in the last day.
QQVMap Q330 Quickview channel map (bitmap, hex)
RTMax
RUDICS temperature Max
RVMin RUDICS Voltage minimum
SBD Iridium timer; shows Enabled/Disabled (Y/N), followed by repetition rate
ESP Sleep mode timer; shows Enabled/Disabled (Y/N), followed by repetition rate
QQV Q330 Quickview timer; shows Enabled/Disabled (Y/N), followed by repetition rate
QST Q330 Status timer; shows Enabled/Disabled (Y/N), followed by repetition rate
SEN External sensor timer; shows Enabled/Disabled (Y/N), followed by repetition rate
SIM SIM of the modem; if blank, the modem has not sent this information to memory.
SIM only shows number here if contact has been made with the Iridium network;
therefore an Iridium antenna is required for this information.
IMEI IMEI of the modem; if blank, the modem has not sent this information to memory
Using RUDICS
The Xi-100b allows you to establish a direct TCP/IP socket connection between a local terminal
and your remote device. RUDICS itself has no underlying protocol.
If you are using the XeosOnline server, Xeos will provide you with the necessary Local Port and IP
for tunnel configuration. If your SIM is provisioned through another provider other than Xeos,
those local IPs and ports must be forwarded to that party.