- 5 -
4.2 Description of the table control unit
The table control unit is set up on a sturdy and level surface and has a secure hold,
thanks to its rubber feet.
All operating equipment (rotational speed regulating knob, clockwise-anticlockwise
switching, warning light and On-Off switch) necessary for efficient work is located on
the ergonomically designed front plate, comprehensible symbols on the front foil
guarantee intuitive operation; everything is carefully considered and arranged
correctly: Your concentration remains on the task at hand.
The connection socket for the foot controller, the changeover switch for hand/foot
operation and a replaceable safety fuse is located at the rear.
A recess for the tool holder is located in the upper housing area: After completing
work, the shafts of the bits and cutters can be inserted here for clean and tidy
storage.
5 Before commissioning:
Attention:
Please comply with the following, supplemental safety guidelines. You help reduce
the risk of injuries and contribute towards the safe operation of the device!
•
The handpiece may not be operated without the supplied pin or matching bits
and cutters! If the collet is empty, or in the "open" position, the motor will not run
and the warning LED on the control unit begins to glow.
•
The handpiece may only be operated with the supplied control unit!
•
You must comply with the rotational speed specifications of the bits and cutters
manufacturers and any other instructions for use (e.g. about contact pressure,
limits in material selection, etc.)! Check the rotational speed set at the control
unit each time it is switched on. Operation with inadmissibly high rotational
speeds can cause the tools to break because of too high centrifugal forces! Risk
of injuries!
•
Always wear protective goggles and a dust mask during work!
•
For the work described in the following, you must make sure that the handpiece
cannot start up inadvertently!
•
Only bits and cutters with a 2.35 mm shaft diameter can be used with the factory
installed collet. Please note that the diameters of the collet must correspond
with the tool shaft.
•
Immediately replace worn or damaged tools! Higher actuating forces place a
load on the device mechanics which can cause the tool to break or splinter!
