Xeeder Zigbee, Руководство пользователя

Страница: 5 / 19

B
Test Cylinder and Power
Cross - Head screw driver
An ordinary tool and should
be prepared by user
.
User prepare
TOOLS
Push and pull to open it
Cylinder cover opener
This tool is used to remove
the cylinder cover .
Vendor offer it free
Inner hexagon screw driver
This tool is necessary while
install cylinder in mortise .
Vendor offer it free
Test Thumb Turn
Beep
Installation steps
1. Punch holes
Each lock installation requires holes on the door.
To punch the holes you must use the template correctly.
Take out the template.On the front side of the template it shows
the edge of the door (on the right direction).
Please always aim the edge of the door line at the real door.
You should turn the template reverse to let it suite another face of
the door.
Firstly mark the height line on both faces of the door.
(height line start from the handle center and it is away from the
ground 1.0-1.1m) Then mark the balance holes by a pencil or
markingpen.Paste the flank face template on the door by aligning
the main. Mark the mortise hole.
Punch all holes by the electric
drill according the marks.
Template should be use repeatly
for all doors punching.
Holes size and position may
different for different model lock
please check it carefully before
start punch.
Holes must not bigger than the
size on the template otherwise
the holes may exposed outside.
The mortise hole on the flank
must be punched at enough
depth otherwise the mortise
could not be placed in.
Put the mortise into the hole and
holding it square to the door
edge, draw around the faceplate.
Remove the mortise and score
the outline with a stanley knife to
avoiding splitting when
chiseling. Chisel a rebate to allow
the latch to fit flush to the
surface.Fix the mortise with the
screws, with the bevel towards
the door frame.
3. Fix the cylinder
Insert the cylinder from front and
tight the screws from back by
using the inner hexagon screw
driver
4.Install front and back boby:
Export the cable from the hole,put the axis,connect the lock front
and back boby with link cable through the hole, ensure plug
correctly connect with the back boby slot,then connect inside and
outside with square shaft,ensure the lock plate and the mortise
connection are reliable,finally screw the lock plate in the door.
5.Install the battery and Battery Pack Cover:
After confirm the positive direction of the battery,closes Pack Cover.
6.Test:
After the installment completed,check if the basic function
works is necessary.
Test Cylinder and Power
Instert the emergency key and trun it to make the latch retracted,
if the lock shows blue light and one beep that is means the
cylinder and power works fine.
Test Thumb Turn
Thumb Turn drives the deadbolt out and retracted manually. And it can
be released automatically by turning the back handle.
Please make sure the back handle and thumb turn works fine before
closing the door otherwise it may cause problem that the lock can not
be opened or closed from inside room.
2.Install the mortise
Punch holes on the door .
User prepare
30
mm dia hole drill bits +
Electric drill
WARNING
For the safety,it is suggested strongly that you check
the operation of the emergency key and back lever
handle under the door in opening status
latch
retracted
4
Lock Installation