Xblue Networks X16 plus, Руководство администратора, Страница: 16 / 54

X16plus Administration Manual
Page 16 of 54 Rev. 1.1.4
3.4 Basic Call
To make an intercom call, dial an extension number (XD10 or IP phone).
To make an outside call, dial a PSTN, an IP Trunk or a Trunk Group number first. After
hearing dial tone, dial the phone number.
3.5 Call Abandon
For each PSTN call, X16
plus
provides the ability to monitor the call status. If the remote
party hangs up, the ongoing call will be terminated.
The PSTN line monitor is accomplished through monitoring the Talk Abandon Time,
polarity reversal or busy tone. The value range of Talk Abandon Time is: "Disable"
100/200/
… / 3000 ms.
◼
image 5.2.2 CO setting set Talk Abandon Time, Polarity reversal and busy
tone.
3.6 Call Pickup
– Group
Each extension belongs to a Pickup Group (1~8). Direct Call Pickup allows extension
users to answer a call that is ringing at other extensions. If dialing "*", allow you to
easily access calls ringing in your group.
◼
image 5.1.1 Ext Setting set extension Pickup Group.
3.7 Toll Restriction
The X16
plus
provides sophisticated monitoring of digits dialed on PSTN/IP Trunks. If a
digit or range of digits dialed on a Trunk line is inconsistent with the dialing extension
’s
COS, the call will be denied. This calling COS criteria can be applied to local calls, long
distance calls, and specific numbers that are considered allowed in areas where other
numbers may be restricted.
◼
The X16
plus
allows for configuration to the Toll Restriction Table. It provides
the following programming items in image 5.5.1.