Xantrex XC1524, Руководство пользователя

Страница: 37 / 80

Installing the XC Series
975-0187-01-01 2–11
Final DC Connections
To make the last DC connections:
1. Connect the negative cable from the negative terminal on the battery (if you are
using only one battery or bank), or the negative ground bar or bus (if you are
using more than one battery or bank), to the negative DC terminal on the
XC Series (Figure 2-1). Use a flatwasher, a lockwasher and a nut (5 included in
the installation kit) to secure the connection.
Tighten the nuts to 3 N-m (30 lb-in.) torque and test that the wire is secure.
2. Connect each positive cable to the correct positive DC terminal on the
XC Series (Figure 2-1). Use a flatwasher, a lockwasher and a nut (5 included in
the installation kit) to secure the connection.
Tighten the nuts to 3 N-m (30 lb-in.) torque and test that the wire is secure.
3. Connect the free end of each positive cable to the correct positive terminal of
the battery, using sufficient torque as recommended by your battery
manufacturer.
4. Connect the free end of the negative cable to the negative terminal on the
battery, using sufficient torque as recommended by your battery manufacturer.
Note: If you are using more than one battery, you will need to connect the
negative cable from each of the batteries to the negative ground bar or bus. The
negative ground bar or bus will then have a single negative cable connecting to
the negative charger terminal.
5. Before proceeding, carefully check the wiring polarity – make sure the positive
terminals of the XC Series are connected to the correct terminals of the battery
(fuses or breakers) and from there to the positive terminals of the battery. Make
sure the negative terminal of the XC Series is connected to the battery negative
terminal (or engine negative bus/DC negative bus). Do not reverse the
connections.
6. Install the DC chassis ground (earth) from the ground stud on the XC Series to
the engine negative bus or DC ground bus.
7. Connect the BTS cable and the remote display cable to the rear of the charger.
WARNING: Shock hazard
Make sure that the DC fuse or circuit breaker is still open.
XC_Charger_Owner.book Page 11 Friday, August 12, 2005 3:23 PM