Xantrex XC1524, Руководство пользователя

Страница: 34 / 80

Installation
2–8 975-0187-01-01
To remotely mount the display:
1. Remove the display as described on page 2–7.
2. Secure the blank plate in the display socket as described.
3. Ensure that the extension cable used for the remote display is long enough to
suit the installation. A standard North American style, 4 conductor (RJ-11)
telephone cable extender is adequate.
4. Use the enclosed mounting template to cut a hole for the display in the chosen
mounting surface.
Take care that there is nothing behind the surface for you to damage.
5. Feed the remote display extension cable through the hole and route it to the
charger. Be careful not to damage the telephone connector locking tab when
routing the cable. You can use some tape to protect the locking tab from
catching on something and breaking off when routing the cable.
6. Remove the adhesive backing on the back of the display.
7. Line up the display with the mounting hole.
8. Firmly press the flanges in place. Do not press in the middle of the display.
9. Once the XC Series is mounted, plug the cable into the bottom connector on the
rear panel of the XC Series.
10. Proceed to “Mounting”.
Mounting
Mount the XC Series using the mounting slots provided.
For marine installations, only the mounting configurations with a check mark in
Figure 1-6 on page 1–11 meet the North American and European requirements.
This is to ensure that any moisture that may be present will not enter the XC Series.
To mount the XC Series:
1. Keep the carton and packing material in case you need to return the XC Series
for servicing.
2. Ensure that you have selected a mounting surface that is clear, flat and allows
for a minimum of 76 mm (3 in.) of clearance on each end for fan circulation.
Important:
Be sure to measure your AC and DC cables and plan the routing of the cables
before drilling the pilot holes for mounting the XC Series.
XC_Charger_Owner.book Page 8 Friday, August 12, 2005 3:23 PM