![background image](http://html.mh-extra.com/html/xantrex/rs3000/rs3000_installation-manual_881442029.webp)
Installation
975-0171-01-01
13
DC Components
Batteries
The RS3000 system requires a 12 volt, lead-acid deep-cycle battery or group of
batteries to provide the DC current that the inverter/charger converts to AC power.
The battery may be a flooded, gel, or AGM type.
See “Battery Information” on page 40 for information on:
•
Estimating the battery size that will meet your requirements.
•
Designing battery banks.
•
Restrictions on the size of appliances.
For information on cabling and hooking up batteries, see “Cabling and Hook-up
Configurations” on page 44.
For detailed information about specific brands of batteries, you’ll need to consult
individual battery manufacturers for this information.
DC Disconnects and Over-Current Devices
The DC circuit from the battery to the inverter/charger must be equipped with a
disconnect and over-current protection device. (Refer to your applicable
installation code.)
Type
This device usually consists of a circuit breaker, a “fused-disconnect,” or a
separate fuse and DC disconnect. Do not confuse AC circuit breakers with DC
circuit breakers. They are not interchangeable.
Rating
The rating of the fuse or breaker must be matched to the size of cables used in
accordance with the applicable installation codes.
Location
The breaker or fuse and disconnect should be located as close as possible to the
battery in the positive cable.
Applicable codes may limit how far the protection
can be from the battery.
Содержание RS3000
