Application Advisory
*DATE*
Page 7 of 8
EQUALS (=)
3D
QUESTION (?)
3F
DIGITS 0-9
30-39
A 41
B 42
C 43
D 44
I 49
L 4C
M 4D
N 4E
Q 51
T 54
U 55
V 56
Y 59
Z 5A
APPENDIX 2 - ZPR68-10 ZONE NUMBER PROGRAMMING
NOTE - All zone cards are programmed when they are installed at the factory. If it
becomes necessary to change the number, follow the procedure outlined below.
TO SET THE ZONE NUMBER
1 - Connect an IR receiver to that zone.
2 - Set the switches on the rear of a Xantech RC68 or RC68+ Programmer to FE.
3 - Using the table, select the button for the number desired. For example, to set the
zone to respond to 03, press the button marked 90. The zone now is identified as 03.
4 - Be sure to reset the switches on the programmer to anything other than FE or FF!
RC-68
01-10 20-48 02-01 03-90
N/U 05-C0
06-50
07-D0
04-40 09-A0 10-30 11-B0
08-20 13-E0 14-70 15-F0
