3
Controllers
URC-2
QUICK START
Perform the following basic steps to begin using the URC-2 immediately.
Installing Batteries
1. Turn the unit over and remove the battery cover. Press the cover Tab in the direction of the arrow on
Tab and lift up. See Fig. 3.
Battery Cover
Tab
Press in direction of
arrow on tab and lift up.
Back Side
of URC-2
Fig. 5
Fig. 6
Battery Cover
(removed)
Batteries
Installed
Be sure to observe
correct polaity!
Fig. 3
Fig. 4
2. Install 4 “AAA” Batteries (Alkaline recommended). Refer to Fig. 4. Be careful to observe correct polarity
for each battery as shown and as marked on the inside of the battery compartment.
3. Reinstall battery cover.
Teaching Single IR Commands
1. Place the URC-2 and the "teaching" remote on a flat
surface, facing each other as shown in Fig. 5.
2. Place the Programming Overlay #1 (supplied) over the
bottom three rows of keys on the URC-2. Refer to Figs.
2 & 6. NOTE: Do not remove the adhesive backing from
this overlay for permanent attachment unless you have no
intention of using the other overlays in the future.
3. Press and release the PGM Key & any desired Source
Key both at the same time. Refer to Fig. 6.
The Status LED will blink Green and the Source LED will
be steady Red.
4. Press and release a Source Key twice (or a Function Key once for
the selected source) under which you wish to place an IR command.
The Status LED will be a steady Green, waiting for an IR signal.
NOTE: It is necessary to press different Source Keys twice, once to
select the bank, the next to select it as a key to learn IR data.
5. Press briefly the desired key on the "Teaching" Remote.
The URC-2 Status LED will blink Amber briefly, indicating the
command was learned, then blink Green, waiting for your choice of
another key.
NOTES:
a) If the Status LED blinks Red two times, then steady Green, an
errror has occurred and the command has not been learned.
When this happens, simply repeat step 5, but this time vary the
distance and/ or the length of time you press the key on the
"Teaching" Remote.
URC-2
"Teaching" Remote
0 to 2 inches
(0 to 50 mm)
1
2
3
URC-2
TV
VCR
SAT
CBL
DVD
TNR
CD
AUX
POWER
T/V
ENTER
VOL
VOL
CH
CH
PR.CH
MUTE
4
5
6
7
8
9
0
PAUSE
STOP
REW
FF
INFO
EXIT
SEL
PLAY
MENU
GUIDE
A
B
C
D
Status LED
will blink
Green
Press and
Release the
PGM and a
Source Key
simultaneously
to enter the
Program Mode
(single
commands
per key).
Programming
Overlay used
(#1)
PGM
CANCEL
DEL
XFER
SEQ
DELAY
EDIT
STEP
