®
8
FLUSH MOUNT ADAPTER
The Flush Mount Adapter allows mounting the IR Receiver in an equipment
cabinet door. This allows IR controlled audio/video components to be controlled
with the cabinet door closed.
This application requires drilling an 11/16” (17.4mm) hole in the cabinet door as
shown in
Figure 9
. It is recommended that the IR Receiver be mounted closer to
the hinged side of the cabinet door so the Electronics Module can be mounted
to an inside wall rather than the door.
1.
Select a location on the cabinet door to mount the Flush Mount Adapter.
Be sure there is at least one inch of clearance from the back of a 5/8” thick
cabinet door to the front of the A/V components to allow room for the
Adapter Locks with the door closed.
(Figure 11)
Also be sure that once
mounted, the IR Receiver will not be blocked by any object to allow ‘line-of-
sight’ between the remote control and the IR Receiver in normal use.
2.
Drill an 11/16” (17.4mm) diameter hole in the cabinet door.
Figure 9
3.
Pinch the Adapter Locks together and carefully slide the adapter through
the hole until the adapter bezel is pressed against the front of the cabinet
door. Be sure to align the thick sections of the bezel at 12 and 6 o’clock for
best left to right off-axis performance. (It will look better that way as well.)
Figure 10
4.
Carefully pull the 8” Ribbon Cable straight back from the IR Receiver and
with the receiver lens oriented to match the orientation of the mounted
adapter (thick sections 12 and 6 o’clock) push the IR Receiver into the back
of the mounted adapter until it snaps into place.
Figure 12
DO NOT ALLOW THE RIBBON CABLE TO BE PINCHED BETWEEN THE
RECEIVER AND THE ADAPTER LOCKS.
Cabinet Door
11/16” (17.4mm)
Diameter Hole
5/8” (15.9mm)
Door Panel
Figure 9 -
Flush Mount Adapter -
11/16” Hole
Cabinet Door
11/16” (17.4mm)
Diameter Hole
Pinch Adapter Locks together
so they will slide through hole
in cabinet door.
Adapter Bezel
Figure 10 -
Flush Mount Adapter -
Install Adapter
