®
7
Figure 6 -
Tabletop Adapter -
Insert IR Receiver
Figure 7 -
Tabletop Adapter -
Insert Electronics Module
TABLETOP ADAPTER
The Tabletop Adapter allows mounting the
IR Receiver in an attractive low-profile case
creating an IR Receiver that can be placed
on any shelf or tabletop.
1.
Remove the Tabletop Adapter Base by
rotating it counter-clockwise as shown
in
Figure 8
.
2.
Position the Tabletop Adapter top so
the lens is facing down as shown in
Figure 6.
Lens
IR Receiver
Ribbon Cable
Pass-Through
8” Ribbon Cable
Tabletop Adapter
Top Inside
To Connecting
Block RCVR Jack
Lens IR Receiver
Ribbon Cable
Pass-Through
Wide Gap
At Top
Tabletop Adapter Base - Inside
Base Lock
Base Lock
Base Lock
Base Locks
Base Lock
Electronics
Module
Socket
Electronics
Module
‘Bottom Notch’
Figure 8 -
Tabletop Adapter -
Remove/Tighten Base
To Connecting
Block RCVR Jack
Lens
Rotate Clockwise
to Tighten
Rotate Counter-clockwise
to Remove
3.
With the 8” Ribbon Cable on the IR Receiver facing up, carefully insert the
IR Receiver into the socket on the backside of the lens as shown in
Figure 6.
The receiver should snap into place when properly inserted.
4.
With the ‘bottom notch’ of the Electronics Module facing you, carefully slide
the module onto the post in the Electronics Module Socket as shown in
Figure 7.
5.
Carefully wrap the 8” Ribbon Cable around the Electronics Module and
extend the plug end of the Ribbon Cable out of the Tabletop Adapter case
via the Ribbon Cable Pass Through as shown in
Figure 7.
6.
Align the Adapter Base to the Adapter Top with the ‘wide gap’ aligned at the
top with the IR Receiver as shown in
Figure 7
. Tighten the base to the top
as shown in
Figure 8.
If this is your application, when finished, proceed to section:
Typical
Connections
.
