Xante ScreenWriter 3, Руководство пользователя

Страница: 192 / 288

6-20 Configuration bb ______________________________________
Flow control is the mechanism the printer uses to signal the
computer that it is ready to accept data. The Flow Control menu
allows you to select XON/XOFF (software) or DTR (hardware) flow
control. The factory default is XON/XOFF.
The Data Bits menu allows you to select either 7 or 8 (the factory
default) data bits.
The Stop Bits menu allows you to select either 1 (the factory default)
or 2 stop bits.
Parallel Configuration
When using the Parallel interface, set the Handshaking menu
(PARALLEL:HNDSHK) for handshaking mode used on your
system. Handshaking options are Auto (Automatic), Compat
(Compatible), Bidi (Bidirectional), and ECP (Enhanced/Extended
Capabilities Port). The factory default is AUTO.
Novell Print Server Configuration
When using the Novell Print Server interface, set the printer for the
NetWare protocol frame type used on your network. You can also
specify a printer timeout on the network.
The Protocol Menu allows you to select 802.3, which is the default
packet type for NetWare versions 3.12 and up, or 802.2 (NO SNAP),
which is the default packet type for NetWare versions prior to 3.12,
as the Novell protocol frame type used on your network. The factory
default is 802.3.
The Timeout menu allows you to set a timeout for the Novell Print
Server emulation. If the printer cannot locate an assigned file server
during the selected time, the Novell Print Server emulation is
disabled. When the file servers are active on the network again,
enable the Novell Print Server interface using XANTÉ Command
Center or the printer’s front panel. Options are Never and 5 minute
increments to a maximum of 30 minutes (the factory default).
IP Address Configuration
When using the IP Address interface, use the keys on the front panel
to set the address as follows: