Xaar XJ128 Series, Руководство по эксплуатации

Страница: 24 / 70

XJ128 and XJ128 Plus Printhead
XJ128 Guide to Operation

Xaar Document no: D031010302 Version A Page 23
Pin Signal name Pin type Function
1 nSS2 Input Chip select for MOSI/MISO
–
chip 2
2 GNDH Supply High voltage ground
3 VPPH Supply 35V high current voltage supply
4 VPPL Supply 35V low current, low noise voltage supply
5 GNDL Supply High voltage, low noise ground
6 nFAULT Output High temp error signal
7 nRESET Input Driver chip logic reset
8 MOSI
*
Input Serial data input select
9 TEST_0 Input Not connected
10 TEST_1 Input Not connected
11 TEST_2 Input Not connected
12 TEST_3 Input Not connected
13 TEST_4 Input Not connected
14 TEST_5 Input Not connected
15 TEST_6 Input Not connected
16 GND Supply 5V logic ground
17 VDD Supply 5V logic supply
18 TEST_10
*
Input Must be tied to VDD
19 SCK Input Main sample clock
– ‘ data strobe ’
20 nSS1 Input Chip select for MOSI/MISO
–
chip 1
21 TEST_7 Input Not connected
22 TEST_8 Input Not connected
23 TEST_9 Input Not connected
24 READY Output
‘ Printhead ready ’ used for signal timing
25 PHO Input Phase order select
26 nFIRE Input Printhead
‘ fire ’ trigger signal
27 MISO Output Serial data output select
28 CLK Input State machine clock
– ‘ sample clock ’
29 VPPH Supply 35V high current voltage supply
30 GNDH Supply High voltage ground
Table 5.1
–
Pin out of electrical connector
5.2 Signal level definition
Low Level represents a logic
“ 0 ”
This is achieved holding the signal to logic ground (GND).
High Level represents a logic
“ 1 ”
This is achieved holding the signal to logic power supply voltage (VDD).
*
Pull-down resistor inside printheads: 2-30k
