Installation indoor monitor
1.
Parallel move the battery cover downward, and take it off.
2.
Insert the lithium battery along the battery jar and set it level, mind the front and
reverse side of the battery.
3.
Fit on the battery cover.
S
tarting Up & shutting down
Install battery to handset, long press
“ON/OFF
” about 3 seconds to start up (about 1
second after shutdown), logo shall be displayed on screen with a sound of “Beep”. Turn
into standby mode.
■
Display: standby picture, signal sign, power sign, time & date
■
In this mode, the screen gets dark after several seconds and turn into power saving
mode, the red LED flashes every 4 seconds. The screen would be lighted if press
again.
■
When battery is in low power (
≤
1 bar), red LED flashes every one second. It
remains you to charge it.
■
In standby mode, long press “Switch key” about 3 seconds to shut down.
Menu Setting
Press the
“
ON/OFF
”
button to turn display ON , long press “
FUNC
” key, enter into
menu setting. Then press “FUNC” key in sequence, it would respectively enter into
“ Time Setting”
→
“Ringing Setting”
→
“Lock Delay Setting”
→
“PIR Setting”.
Date & Time setting
n
Press "
↑
/
↓
" key to choose the figure of date& time.
n
Press "
+
/-"key to adjust digit-size
.
n
Press "OK" key to affirm and turn back to standby condition.
Ringing setteing
n
Press“
↑
/
↓
”key -
》
choose the music you like (12 pieces in total)
n
Press“+/
-
”key-
》
increase or decrease the volume level (7 levels in total)
n
Mute: long press"-"key still there is a mute symbol.
n
Press "OK" key, confirm and back to standby condition
Lock Delay
n
Press “
↑
”or “
↓
”key to adjust the time, the range of the time is 1~6 seconds.
n
Press "OK" key, confirm and back to standby condition
Unlocking Explanation
Only in the state of intercom, press “ON/OFF Switch” to unlock with unlocking symbol
showing on the screen.
PIR : ON/OFF
n
Press“
↑
”or “
↓
”to choose “ON” or “OFF”, the setting value shall be sent to outdoor
camera by pressing “OK” key