Key introduction
：
A. Indoor monitor Keys
（
7pcs Key
）
:
1.
（
OK
key
）
: work as a off-hook key and a on-hook key; as a speaking key.
2.
（
↑
UP key
）
: as an adjustment key for choosing.
3.
（
↓
DOWN/
Preview key
）
: as an adjustment key for choosing when long press it;
as a preview key when short press it.
4.
(
monitor key): work as monitor key for standby mode
5.
(
FUNC
Function key): as a multifunction key, such as a photo-taking key
, a
time setting key, ringing setting key
and a delete setting key.
6.
Switch key "
ON/OFF”
: as a power "
ON/OFF”
key, the screen would be light when
short press it.
7.
Volume key(
+/-
)
B. Outdoor unit keys
1.
Doorbell key “
Call
”: ring the bell and trigger photo-taking there is no one on-hook.
2.
Reset: match the communication code with the handset
Installation Guide
Position the camera so the area to be monitored is easily visible, optimally 5ft (1.5m)
above the ground. Do not position the camera in direct sunlight, or where it will be
exposed directly to rain or snow.
NOTE: For best results, the visitor should stand 2.5~5ft (0.8~1.5m) away from camera.
Installation Outdoor unit
1. Cut a hole large enough to run the min. 21AWG 2-conductor wire to the door unlock
device through the wall, as well as to the included power supply.
2. Install the camera bracket to the wall with three screws. Use screw anchors if the
bracket is mounted on drywall or brick.
3. Run the 2-conductor wire from the camera through the wire hole in the bracket to the
optional door unlock device.
4. Install the rechargeable lithium ion battery into the camera. The battery will act as a
backup power source in case of a power outage.
5. Connect the AC adapter (see Camera Wiring Diagram ).
6. Install the monitor battery and turn on the camera and monitor. If the camera is not in
the bracket, the tamper alarm will sound. Press the
“
OK
”
button on the monitor
repeatedly to disable the tamper alarm.