X-TREME XG-550, Руководство пользователя

Страница: 17 / 31

Page17
How To Adjust Chain Tension
1.) To set the chain tension, loosen the axle nuts.
2.) Then locate the chain tension bolts. These bolts go from the rear axle to the frame.
When you tighten the nuts on these bolts, they pull the whole axle and wheel back,
tightening the chain.
3.) Adjust the chain until when pushing down in middle you achieve 1/8 to 1/4 inch
movement. These bolts also controls wheel alignment, be sure to center the wheel in
the center of frame.
4.) After you have adjusted your chain and aligned your wheel tighten the axle nuts.
How To Install Handlebars
1.) Place handlebars on lower half of bar clamp.
2.) Locate top half of bar clamp and the four allen bolts.
3.) Install top half of clamp with the four supplied allen bolts.
4.) Adjust bars and tighten bolts.
How To Install Front Brake
1.) The assembly is held in place on the front side of the bracket on the fork and with the
single 10mm bolt from the front. Tighten this bolt until it is "snug" but not so tight that
the brakes will not move in and out.
2.) Once the brake assembly is mounted the pads are held in place magnetically with the
Wide Side up, the pad with One Slot to the outside and the pad with Two Slots on the
wheel side.
3.) The brake cable should be adjusted loose until the wheel is installed and then
adjusted first where it goes through the bolt, then at the brake handle and at the brake
assembly until smooth braking is achieved. Adjustment of brakes takes time to
achieve proper stopping.
4.) With brake assembly mounted proceed to the directions for mounting the wheel.
How To Mount Front Wheel
1.) Set the scooter on a box that holds the front far enough off of the ground for the wheel
to clear while installing. It may be helpful to have an extra set of hands to hold and
align the brakes, wheel, axle & spacers.
2.) Start by putting the axle through the Left Side Fork (as determined by standing on the
scooter and facing forward).
3.) Place the Smaller Spacer into the Wheel Hub and then place the Wheel between the
Forks with the Disk sandwiched between the Brake Pads.