Page18
OPERATION GUIDE
Pre-Ride Inspection
WARNING – THE PRE-RIDE INSPECTION MUST BE COMPLETED BY ALL RIDERS
PRIOR TO USING THE XA-150. FAILURE TO PERFORM THIS INSPECTION CAN
LEAD TO SERIOUS INJURY.
Inspection Check List
Check engine oil and add if required
.
Check the engine for leaks.
Check the fuel level and add fuel if necessary. See page 13 for safety
guidelines when handling gasoline.
Test front and rear brakes and adjust if necessary. When brakes are
completely depressed, the ATV should not move when pushed.
Test parking brakes and ensure they operate properly.
Check all four tires for proper inflation pressure using the tire pressure gauge.
Inspect each tire for wear & tear and tread depth.
Check proper throttle operation. When let go, the throttle should spring back
to the idle position.
Inspect the ATV and test all nuts/bolts for tightness. Ensure all nuts/bolts are
securely fastened.
Test the steering to ensure the steering operates properly and freely when
turning right and left.
Test the Engine Kill Switch. With the ATV engine and the parking brake
applied, press the kill switch and the engine should stop completely.
If the ATV does not pass every pre-inspection check point - DO NOT
RIDE THE ATV until the issue has been resolved. Serious injury can
occur if the ATV is not functioning properly.
STARTING THE ENGINE
Always us the following procedure below when starting your XA-150.
WARNING – NEVER RUN THE ENGINE IN AN ENCLOSED AREA. EXHAUST
EMISSIONS ARE DANGEROUS AND CAN LEAD TO DEATH
.
Starting using the Electric Start
Ensure the ATV is on level ground and the parking brake is engaged
1. Insert the key into the ignition and turn to the on position
2. Depress the hand brake
3. Press the electric start button while slightly turning the throttle
4. Once the ATV is running, release the starter button.
NOTE: Do not use the electric starter button for more than 5 seconds at a time.
Release for at least 10 seconds before pressing again.
5. When starting and warming up, be sure to maintain the throttle slightly.
6. Allow the engine to warm up for a few minutes before riding.
