11
7.Function Viewing (1)
You can press the "Function Viewing Button" (1) to observe the setting
details.
Press this button to check the setting data of the current mode when
the system is running.
8.Saving parameters
SANY-PUMP stores set up parameters.
The settings are not deleted in the absence of electricity. When the e-
lectrical current comes back, they will automatically reappear in your
display.
9. Pump running conditions
1) Time Adjusting Mode (B)
:
The pump is running at any time.
2) Time-intervals Mode (C)
:
The pump starts and stops during the time-interval you’ve set
.
3) Temperature Mode (D)
:
The pump runs when the water temperature, corresponds to the set
temperature; Vice versa, it stops when the current temperature no lon-
ger corresponds to that you've set.
4) Time/Temperature Mode (E):
The pump works only when both time and temperature settings corre-
spond to the present ones; conversely, the pump does not works.
10. Note
1) When the Operating-Status-Mode LED is off, the pump does not
work. The circulator is in operating state when “Operating Status Mode”
led is on. When the “Operating Status Mode” LED flashes, the pump is
on but it is not working because the settings (time or temperature) do
not coincide with those set.
2) The mode can only be switched when the pump is in “non-working”
state.
3) For deleting a setting, log onto the affected mode and press
"OK" (5).
The “Start” and “End” indicators will extinguish simultaneously, and the
range will be canceled.
4) Please make sure that current time is correct, before setting the time
range.
