-
Do not use the helmet if the VPS has not been assembled properly.
-
Since the VPS does not assure you the same protection as the one provided
by the visor, it has to be used only when the helmet visor is lowered
WIND PROTECTOR
(Available as standard or accessory/spare part).
I This accessory allows improved helmet performance under certain conditions of
use. The Wind Protector reduces unpleasant infiltrations of air under the chin.
See Fig. 10 for assembly and disassembly.
REMOVABLE INNER COMFORT PADDING
To remove the inner comfort padding, lift the VPS and open the visor completely (see
instructions above).
8.
Cheek Pad Disassembly
8.1.
Remove the Wind Protector (see instructions above) and open the chin strap
(see instructions). Pull the front padding of the left cheek pad towards the insi-
de of the helmet to undo the snap fasteners on its back (Fig. 11).
8.2.
Remove the padding of the left cheek pad from the helmet by pulling the rear
flaps out of the cavity between the polystyrene cheek pad and the outer shell
(Fig. 12).
8.3.
Pull the left band of the chin strap out of the slot located in the padding of the
left cheek pad.
8.4.
Repeat these steps with the padding of the right cheek pad.
Note: It is not necessary to remove the polystyrene cheek pads from the hel-
met shell.
9.
Liner Disassembly
9.1.
Unhook the left rear flap of the liner from the support fixed to the polystyrene
inner shell by slightly pulling the comfort padding towards the inside of the hel-
met (Fig. 13). Then repeat the same steps to remove the central flap as well as
the right flap.
9.2.
Hold the left front part of the liner and pull it upwards in order to remove the
corresponding liner flap from the support fixed to the polystyrene inner shell
(Fig. 14). Then repeat the same steps for the central front and right flap.
9.3.
Completely remove the liner from the helmet.
10.
Liner Assembly
10.1. Insert the liner correctly into the helmet and fit it well against the base.
10.2. Insert the left front flap of the liner into its seat on the support fixed to the poly-
styrene inner shell and push it downwards until it is completely locked. Follow
the same steps for the central and right flap (Fig. 14).
NOTE: Check the correct assembly of the liner front area by lifting and lowe-
ring the VPS. These movements should be smooth. If this is not the case, repe-
at the steps 9.2 and 10.2.
10.3. Insert the rear right, central and left flaps of the liner into the relevant support
19
Содержание X-661
