16
X GLOO
®
•
Windeckstr. 4
•
83250 Marquartstein
•
Germany
10.1 MATERIAL
• All materials used have been carefully selected for their resistance to change from light
exposure and have been subjected to rigorous tests. Nevertheless, the material may change
color (fade) if there is strong UV exposure (when set up at high altitudes or through a long
period of use). It is not possible to accurately predict when fading may become visible, due
to the different influencing variables. White material also tends to yellow through UV
exposure and exposure to dust and dirt.
• The materials used are waterproof and the essential seams are sealed with sealing tape.
Nevertheless, water can still penetrate the tent in the event of a downpour or prolonged
periods of rain, especially through the zippers.
• Electrical/electronic devices and moisture-sensitive products must be protected from water
exposure to water. Their use is at the discretion and risk of the user.
• Compared to the dyed X GLOO material, which is available in the standard colors black,
white, gray, red and blue, all other colors and designs are applied by digital printing to one
side of a white material. Due to the nature of the digital printing process the back side of
the material remains white, but printing on the opposite side may shine through depending
on the amout of light striking the material.
10.2 REMOVING THE ROOF
The roof can be separated from the tubes.
• To do this, first release the webbing from the strap
adjusters found between the tubes and the roof at
the the end of each of the four tubes (a).
• Next, unhook all cords from the roof-tube connectors
by lifting one of the points in the connector and then
unthreading the cord.
ATTACHING THE ROOF
• In reverse order: hook the cords on the inside of the
roof into the roof-tube connectors found on all tubes
(d / c / e).
• Next, connect the webbing to the strap adjusters
found between the roof and tubes near the tube
ends. Adjust the length of the webbing so that there
is about 2 cm of space between the end of the roof
and the upper edge of the protection strip (a).
10.3 REPLACING THE PROTECTION
STRIPS
Replaceable protection strips are attached to all four
tube ends of the tent. To remove a protection strip, first
release the webbing from the strap adjusters and then
thread these, as well as the plastic toggles, out of the
protection strip.
2 cm
a
b
c
d
