Skywalk GmbH & Co. KG - Windeckstraße 4 - 83250 MARQUARTSTEIN | GERMANY
1.
LAY OUT THE MATRIX
Spread the X-Gloo Matrix out in the area intended for setup. Try to
make sure that the tube endings of the X-Gloo are positioned
approximately where you want them once the tent is inflated. This
way you can avoid having to reposition or handle the tent again.
8x8 ONLY: Zip in the Middle Wall
Since the entrance height of an assembled X-Gloo 8x8 is very high,
we recommend zipping in the Middle Wall before inflating the tent.
PLEASE NOTE:
Only the outer side of the Middle Walls are
equipped with a Zipper Rain Protector. If you should choose to
attach the Middle Wall with the outer side facing inwards (so
that a logo printed on the outside is be visible from the inside of
the tent for example), the waterproof quality of the tent in the
area of the zipper can not be guaranteed.
2.
TEST THE VALVES
INFLATION VALVE:
The Inflation Valves are air-tight and perma-
nently welded to the Bladder inside each Tube. Each Inflation Valve
consists of a rubber check valve and a threaded valve cover
(1)
.
The check valve inside the housing prevents air from escaping. In
order to prevent dirt from entering, the valve cover is screwed onto
the housing after inflation is complete.
OVERPRESSURE/DEFLATION
VALVE:
Beside the Inflation
Valve you will find a red Over-
pressure Valve
(2)
which opens
automatically as soon as the
Bladder is properly pressurized.
To deflate the Tubes, unscrew
the housing of each Overpressure
Valve by turning it counter-
clockwise
(3)
.
The function of each Overpressure Valve should be tested before
inflation. To do this, unscrew the housing and make sure that the
spring can be pushed in. Tightly close each valve after testing.
PLEASE NOTE:
Sand and dirt can clog the spring inside the
Overpressure Valve so that the function is negatively influenced.
8
SETUP
!
!
Inflation with the Hand Pump
The standard Hand Pump included in
delivery is equipped with different valve
sockets and an air hose. Do not kink or
press down on the air hose, to avoid air
leakage or damage!
PLEASE NOTE:
See the notation on the
hose connection:
Inflate | Deflate
Inflation with the Electric Pump Bravo
0V10* and Bravo 2000*
Screw the hose (included in delivery) to the
correct opening on the pump.
PLEASE NOTE:
See the notation on the
hose connection:
IN = Inflate | OUT = Deflate
Stick the plug into the outlet. Please note
that the Bravo 2000 has a booster, which can
be turned on with the switch. Please read and
folllow the operating instructions included
with the Bravo OV10 and Bravo 2000.
*120V and 230V models available.
Inflation with the Bravo Turbo Max
for 12V automobile battery
The Bravo Turbo Max can be connected to a
12V automobile battery. To avoid draining
your battery, make sure that it is fully
charged or that the vehicle is running while
operating the pump. Please read and follow
the operating instructions included with
the Bravo Turbo Max.
Connect the cable clamps to the respective
connections of the battery (red =
+
, black =
-
)
and adjust the pressure control to 3 PSI.
!
!
1
2
3
!
