Skywalk GmbH & Co. KG - Windeckstraße 4 - 83250 MARQUARTSTEIN | GERMANY
10
STABILISATION
STABILISATION WITH WATER BALLASTS
One Water Ballast Set consists of 8 parts in two different sizes —
4 small ballasts for the inside of the Tubes and 4 large ballasts
for the outside of the Tubes. A Water Bladder is located inside
the outer cover, to be filled with water. A Fill Set with different
adapters is included in delivery for this purpose.
Step 1:
Attach the hose with correct adapter to the faucet
(1)
.
Step 2:
Open the ballast cover and pull the inner Water Bladder out
until the Fill Valve is visible
(2)
.
Step 3:
Open the Fill Valve, insert the other end of the hose and fill
with water.
Step 4:
Remove the hose, and then close the Fill Valve and the
cover.
Step 5:
Now connect the Water Ballasts to the clips on the Tube
endings
(3)
. The smaller Water Ballasts are attached
on the inside of the Tube endings, and the larger Water
Ballasts are attached to the outside of the Tube endings.
The underside of each Water Ballast is recognisable by the
rubber coating. Depending upon the wind conditions, the
lighter, inner ballasts may be adequate for securing the
tent.
Step 6:
Tighten the straps on the clips so that the Water Ballasts
prevent the tent from rising. Thus, optimal stability is
achieved.
1
3
2
