Pg. 26
v.1.1
13.
Check connectors, verify that connections are not loose
14.
Check landing gear
15.
Hold one of the pylons in one hand
16.
Grasp the landing gear with the other hand
17.
Verify that landing gear is firmly attached
18.
Repeats steps a-c with the other pylon
19.
Reinstall both pylons
20.
Reinstall propellers
21.
Perform a preflight inspection found on page 24 Platinum only:
22.
Connect X PlusOne to mission planner
23.
Connect battery and check battery voltage displayed
24.
Disconnect the battery and measure its voltage with a volt meter
25.
Verify that the measured value is within ±0.1 V of the value displayed in mission planner
iii
Control Check
A control check should be performed during the periodic inspection
1.
Remove the propellers
2.
Power on transmitter
3.
Install battery and connect power
WARNING: Remove propellers before arming
4.
Arm the motors
5.
Slowly increase the throttle until the motors begin spinning
6.
Test each control input and check that the motors respond as shown in the table below
Control Input
Left Wing
Motor
Top Pylon
Motor
Bottom Pylon
Motor
Right Wing
Motor
Elevator forward
=
faster
slower
=
Elevator backward
=
slower
faster
=
Aileron right
faster
=
=
slower
Aileron left
slower
=
=
faster
Rudder right
faster
slower
slower
faster
Rudder left
slower
faster
faster
slower
7.
Disarm the motors
8.
Disconnect battery
9.
Power off transmitter
Safety
DO NOT use aged, chipped or broken propellers.
Recommended storage temperature: between 64° F to 82° F.
Refer to section 1.1 for more information about the safe use of the battery.
