Wylie Spray Wyng II, Руководство оператора и каталог запасных частей

Страница: 29 / 36

25
If the breakaway becomes loose, check the setting of the
coil spring, poly spring and condition of the shock.
Adjusting Outer Wing
The outer wing, as it unfolds vertically, should come to rest
on the same level with the center section and inner wing.
The outer wing rests against a poly pad. If the outer wing
unfolds past level, shims can be placed between the poly
pad and the frame.
Adjusting Tilt Cylinder
The tilt cylinder raises the inner wing to an approximately
15º angle. The wing should be level when the tilt cylinder
is completely extended. To adjust the wing, extend the
tilt cylinder. Lower the complete boom till the tilt section
is resting on a support such as a sawhorse. Remove the
pin from the cylinder clevis, screw the clevis in or out as
needed, then replace the pin.
Maintenance
Figure D7
Breakaway Adjustment
Poly Spring >
< Shock
Coil Spring >
Cable
Figure D8
Breakaway Reset
Figure D9
Outer Wing Adjustment
< Poly Pad
< Set Bolt
< Poly Spring
Shock >
< Coil Spring
Figure D10
Wing Tilt Adjustment
< Cylinder Clevis