Wylie Cone Trailer, Руководство оператора и каталог запасных частей

Страница: 16 / 32

12
Figure A7
Pressure Relief Valve Adjustment
The Hi-Rise pump cylinder is equipped with a pressure
relief valve to prevent excess force between the drive
wheel and the ground wheel. The drive wheel should
engage the ground wheel with enough force to drive the
pump without slippage, but not so much that the drive
wheel is flattened.
If the pressure must be increased, remove the cap and
loosen the jam nut. Rotate the adjustment screw clockwise
(tighten). Adjust in ½ turn increments. Rotate counterclock -
wise (loosen) to reduce the pressure. Once the pressure
is set, tighten the jam nut and replace the cap. Make sure
that the washer is in place between the cap and jam nut.
< Jam Nut
Pressure Port >
Line to T
ractor
< Washer
Cap >
Adjustment Screw >
Inspection & Setup
Steerable Trailer
The 1,250 / 1,600 gallon Steerable Trailer is usually trans -
ported with the rear axle locked in the road position. The
Steerable Trailer is equipped with crossed tie rods that
connect the front and rear axles.
To change from transport to field position, remove the pin,
move each tie rod from the frame mount to the axle mount,
and install the pin.
Figure A8
Steerable Trailer
Tie Rod >
Frame Mount >
Front Axle Mount >
Figure A9
Tie Rods In Field Position