wurth STP 28-A, Руководство по эксплуатации

Страница: 14 / 154

14
Tool Specifications
Intended Use
The machine is intended for making separating cuts
and cut-outs in wood, plastic, metal, ceramic plates
and rubber while resting firmly on the workpiece. It
is suitable for straight and curved cuts with mitre
angles to 45°. The saw blade recommendations are
to be observed.
The user is responsible for damage caused by usage
other then intended.
Before Putting into Operation
The batteries are partially charged and delivered in
idle state. The battery must be activated before using
for the first time. For this, place the battery onto the
charger for a short time. The LED
3 on the battery in-
dicates the charge condition.
When the battery is not used for longer periods, it
switches to the idle state. In order to use the battery
again, it must be reactivated.
When the battery is completely discharged, it
switches off automatically (deep discharging not
possible). When the power tool is switched on none-
theless, the battery delivers only brief current pulses.
The power tool “flickers” as an indication that the
battery must be charged.
As a general rule: Should the power tool not be op-
erative after inserting the battery, place the battery
onto the charger. The indicators on the battery and
the charger then provide information about the bat-
tery condition (see main figure).
At low temperatures, further operation is possible
with reduced power output. The battery switches off
automatically below –10 °C.
Battery Charging
A battery that is new or has not been used for a
longer period does not develop its full capacity until
after approximately 2 – 3 charging/discharging
cycles.
To remove the battery
4
, press the unlocking buttons
5
and pull out the battery toward the rear.
Do not
exert any force.
Please refer to the enclosed “Battery Charger” in-
structions for the operation of the battery charger as
well as for a description of the charging process.
The battery is equipped with an NTC temperature
control which allows charging only within a temper-
ature range of between –10 °C and +66 °C. A long
battery service life is achieved in this manner.
A significantly reduced working period after charg-
ing indicates that the batteries are used and must be
replaced.
❏ Observe the notes on environmental protection.
Charge-control Indicator (see Figure )
The battery 4 is fitted with a charge-control indica-
tor
3
.
By pressing the button 17 , the battery charge can
also be checked when the battery has been re-
moved, or when the machine is at a standstill (ma-
chine must be switched off for at least 1 minute). Af-
ter approx. 4 seconds the battery charge display au-
tomatically turns off.
❏ When the first display element begins to flash (0 –
10 %) the battery is almost empty and must be
recharged.
Cordless Jigsaw STP 28-A
Article number 0700 217 X
Rated voltage 28 V
Stroke rate at no load
1. gear
2 100 min
-1
1. gear 2 800 min
-1
Stroke 26 mm
Cutting capacity, max.
– Wood
135 mm
– Aluminium 30 mm
– in non-alloy steel 10 mm
Bevel cuts (left/right) 0
–
45
°
Weight without battery, approx. 3.5 kg
Battery Li-Ion
Article number
0700 956 730
Rated input power NTC
Capacitance 28 V
Weight, approx. 3.0 Ah
Battery 1.0 kg
E
STP 28-A.book Seite 14 Dienstag, 13. Mai 2008 9:56 09