Würth 0891 385 008, Перевод оригинальной инструкции по эксплуатации

Страница: 15 / 164

15
eak tightness:
▸
Pump the empt device up to 2 bar.
(Fig. )
3
The pressure must not fall b more than 0.5 bar
inside 30 minutes.
Function:
▸
Pull the piston manometer
[8]
up.
(Fig. )
3
Pressure escapes.
The lever on the shut-o valve [6] can be
locked and unlocked using the locking
wheel [12] .
After locking
[12b]
unintentional spra -
ing is prevented. (Fig. 11)
▸
Unlock the locking heel [12a] and activate the
shut-o valve
[6]
. (
Fig. 11)
3
Shut-o valve must open and close.
rrange for immediate replace -
ment of damaged or non func -
tioning parts either b our
service department or b service
partners authorised b us.
Start-up
Observe the notes in the “safet section.
The device must be in an upright posi -
tion.
When filling from a ater pipe, the
pipe or a hose must not extend into the
container.
▸
Pull the red knob of the piston manometer [8] up
until the container is depressurised. (
Fig. )
▸
Press the plunger ith handle [10] do n and
rotate it in an anticlock ise direction.
(Fig. )
3
Plunger ith handle is locked.
▸
Screw the pump
[2]
out of the container.
(Fig. )
Recommendation for mixing of spra
li uid in the device or pre-mixing in
an external container: Fill up 1/3 ith
ater, then add the spra ing agent and
then fill the remainder ith ater.
▸
Fill the spra li uid into the container [1] . (Fig. )
▸
Check the filling height ith the aid of the
scale [11] on the container. (Fig. )
▸
Screw the pump
[2]
into the container.
(Fig. )
▸
Press the plunger ith handle [10] do n and
rotate clock ise.
(Fig. )
3
Plunger ith handle is unlocked.
▸
Create the desired pressure in the container.
(Fig. )
Note
The maximum pressure should not
exceed 3 bar (red line on the piston
manometer,
g. )
. If the maximum
pressure is exceeded, the safet valve
triggers and releases the overpressure.
▸
Press the plunger ith handle [10] do n and
rotate it in an anticlock ise direction.
(Fig. )
▸
Plunger ith handle is locked.
Spraying
Observe the notes in the “safet section.
Onl operate the device verticall or
suspended in an upright position.
Prevent the drift of spra droplets onto
surfaces that must not be treated.
Observe the agent manufacturer’s
regulations!
▸
Hang the device over the shoulder.
(Fig. 1 )
Note
To prevent dripping, hold the spra tube
up ards hen first spra ing and activate
the shut-o valve until no more air-con -
taining li uid comes out of the nozzle.
▸
Unlock the locking heel [12a] and activate the
shut-o valve
[6]
.
(Fig. 11)
3
The spra ing begins.
▸
Monitor the piston manometer
[8]
to ensure
optimum spra ing pressure. (Fig. )