Würth 0715 94 50, Перевод оригинальной инструкции по эксплуатации

Страница: 12 / 152

12
Components
Overview (fig. I)
1 Power supply unit
2 Power cord
3 Power cord to soldering iron
4 Potential equalization jack
5 Calibration potentiometer
6 Power switch
7 Viscose sponge
8 Sponge container
9 Soldering tip
10 Soldering iron
11 Holder
12 Funnel holder
13 Operation mode indicator
14 Temperature scale
15 Rotary knob
16 Fuse / fuse switch
17 Power cord
Technical specifications
Item 0715 94 50
Power supply unit
Performance 60 W
Primary voltage 220 V, 50/60 Hz
Secondary voltage 24 V
Version Protective insulation
Fuse 315 mAT
Soldering iron with soldering tip
Performance 60 W / (350 °C)
Voltage 24 V
Heating-up time Approx. 60 s
Weight without cords approx. 60 g
Proper use
The device is designed for the intended use only,
i.e. it must only be connected and operated as
described in the operating instruction. The device is
designed for soldering using genuine Würth system
accessories.
Any other use is considered improper use.
The user is liable for damage resulting
from improper use.
Scope of delivery
Upon receipt, check that the delivery is complete
and in good order.
The device consists of:
■
Power supply unit
■
Power cord
■
Soldering iron with soldering tip
■
Holder with viscose sponge
■
Operating instructions
Start up [fig. I]
Make sure that the operating voltage conforms with
the data specified on the type plate.
■
Set the power switch [6] to 0.
■
Plug the power cord [17] into the rear of the
device. Plug the power cord into the socket.
■
Connect the soldering iron [10] with the power
supply unit and place it in the holder.
Note
Do not hit the soldering iron against
hard surfaces, since the ceramic heat-
ing element is fragile.
■
Moisten the sponge [7] well and place it in the
holder [8] .
■
Switch on the device.
■
Set the required temperature using the rotary
knob [15] .
■
If fixed temperatures are required: see "Setting
fixed temperatures".