User Manual
17
y
Select “
Sleep
” by pressing “
↑
” and “
↓
”, and “OK” to confirm.
y
Press button
to make Sleep mode enabled
y
Press button and
to decrease/increase the time of sleep mode, sleep time is displayed at the
bottom of LCD. Press
to save and confirm. Machine auto enter sleep mode after pre-set timing value,
press any button activates the machine from sleeping mode.
y
Press T button return to real time IR mode.
y
Adding Voice Annotation to Saved Data
Voice annotation can only be added to an image prior to storing it. After capturing an image, the Image Capture menu
appears. To add a voice annotation to the image:
y
Press the “Voice”.
y
Press “Record” to start the recording.
y
Speak into the Imager’s microphone opening. When done recording, press the softkey labeled “Stop”. Up to 60
seconds of voice annotation can be recorded for each image. Once it reaches 60 seconds, recording will stop
automatically.
y
Press “Play” to replay the voice annotation before saving.
y
Press “Save” to save the voice
annotation.
Listening to Voice Annotation
To play the voice annotation already stored with an image on the UFlash or SD card:
y
Perform the steps in the “Reviewing and Deleting Stored Images” section to bring the desired image to the
EASIR-9
’
s display.
y
Press the “Voice”.
y
Press the “Play”.
The saved voice annotation will be replayed through the imager’s speaker.
Changing the Temperature Units
The EASIR-9 will display temperature in Fahrenheit or Celsius. To change the temperature units:
y
Press
to display the main menu.
y
Press the “Setup”
y
Select “Tunit” by pressing “
↑
” and “
↓
”, and “OK” to confirm.
y
Press
for Celsius or
for Fahrenheit.
Doing spot analysis
EASIR-9 supports single spot measurement. The location of center spot can be adjusted in live image:
