
48
Montage- und Betriebsanleitung
Installation and Operating Instructions
EN
NOTE! Damage from failure to observe the minimum clamping depth in the
hydraulic chuck!
Observe the prescribed values for the minimum clamping depth (see
Tab. 2: Technical Data in [mm] or Tab. 3: Technical Data in [inch]).
NOTE! Damage caused by tool length adjustment with clamped tool!
Do not change the tool length adjustment as long as the tool is
clamped.
INFORMATION
Actuation of the stop screw for axial tool length adjustment is pos-
sible from both sides.
Adjust the hydraulic chuck to the tool length by turning the stop screw
3.
for the axial tool length adjustment using an appropriate Allen key with
T-handle.
Adjusting the tool length
Fig. 10:
Montage- und Betriebsanleitung
Installation and Operating Instructions
49
EN
WARNING! Failure to clamp up to the stop and failure to observe the
minimum number of rotations can cause the tool to fly off like a projectile
and cause serious injuries!
During clamping, screw in the clamping screw up to the stop, observing
the specified minimum number of rotations (see chapter 4.4 Technical
data).
Clamp the tool
Fig. 11:
INFORMATION
The clamping screw is not secured against falling out!
Ensure that the clamping screw is clean.
Turn the clamping screw up to the stop using an Allen key with T-handle
4.
(see Fig. 11: Clamp the tool).
Set a torque wrench to a tightening torque of 7 Nm.
5.
Tighten the clamping screw to the stop with the aid of the torque wrench.
6.
RESULT
The tool is now fully clamped in the hydraulic chuck and can be
used.