V3 © 2019 WT SHA DE
G22
GE
NERA
L
{T} 877.294.3580 • {F} 51
6.294.0444 • {E} inf
o@WTS
had
e.
c
om • 77 S
ec
ond A
ven
ue • Gard
en C
it
y P
ark, Ne
w Y
ork 11040
9. Finishing Touches
Install the Child-Safety Tension Device:
Pull the Child Safety Tension Device and depress slightly so it
slides to the bottom of the chain loop. When installed properly,
the chain should not be too tight that it hinders operation,
should not be able to be pulled away from the wall any further
than 6” and the chain connector should not be able to be
opened without removing the Tension Device. Using two of the
long screws, included in the hardware box, install the Tension
Device. It can be jamb, wall, or sill mounted. Select the best
method of installation for your application type.
Fascia Installation:
Once the brackets have been installed and
the shade has been mounted in place, locate the correct fascia
for the shade. Hook the top of the fascia into the groove on the
top of the bracket then press the bottom of the fascia to snap
it into the groove at the bottom of the bracket. Sometimes the
fit is tight and may require some force to snap in place.
To remove the fascia: Pull down on the bottom flap of front
fascia to unhook and simply lift the fascia off of the bracket.
If you are having trouble with this, or for removing rear fascia,
you may be able to slide the fascia left or right to unhook from
one of the brackets, making it easier to remove from the other.
End Cap Installation:
If ordered, End Caps will be in the hardware
box. These caps require no tools to install. Simply clip on to the
end of the bracket. For applications with fascia, insert the tab
of the end cap between the fascia and the bracket and press
into place. Tabs can be bent slightly for a tighter fit.
Idle Cable Support Kit Installation:
Idle Cable Support Kits can be installed horizontally across the
width of a shade to lend support to sagging fabric in sloped or
skylight applications. You may install as many kits as you feel
are necessary.
Unscrew the top and bottom of one of the barrels, and slip one
end of the steel cable through the hole in the top. Secure the
wire by crimping one of the studs to the end of the wire and clip
off the excess wire (so that when the pieces are screwed back
together, the crimp and end of the cable are on the INSIDE of
the barrel).
Install the bottom of the barrel either through the large hole in
the bottom (jamb mounts) or by installing the small angle to the
wall and attaching the bottom of the barrel with a small screw
(provided). Reattach the top and bottom of the barrel, only a
little so that it is threaded but not tight. DO NOT TIGHTEN ALL
THE WAY. You will need the extra space to tighten the cable
later.
Cut the Cable Sleeve to 2” shorter than the width of the shade,
and slide the cable through the sleeve.
Separate the top and bottom of the remaining barrel. Install to
match the height of the first barrel (use a level to ensure they
are parallel). Insert the cable through the top of the barrel and
stretch the cable as much as you can to determine where to
place the stud. Crimp and cut as previous. Screw the top of
the barrel into the bottom barrel. Now tighten both the top
and bottom barrels by screwing them together as tight as
necessary to keep the wire very taught.
Wire Crimping
Fascia Attachment
End Cap Attachment
Child-Safety Tension Device
INSTALLATION INSTRUCTIONS -
™
