V3 © 2019 WT SHA DE
G20
GE
NERA
L
{T} 877.294.3580 • {F} 51
6.294.0444 • {E} inf
o@WTS
had
e.
c
om • 77 S
ec
ond A
ven
ue • Gard
en C
it
y P
ark, Ne
w Y
ork 11040
If using Side/Center Channel or Guide Track, you must
install it at this point. It can be installed in a variety
of ways using double sided tape or screws.
*For Guide Tracks: Replace the standard hembar end
caps with the wheeled end caps.
Jamb Mount Applications: Align the flat backside of
the channel/ track with the back side of the bracket
(for regular roll installations) or the front side of the
bracket (for reverse roll installations). If using screws,
carefully insert the screw into the channel/ track and
secure to the window jamb through the back of the
channel/ track (you may wish to pre-drill holes to
make it easier). You must make sure the screws are
flush inside the channel/ track so as not to interrupt
the operation of the shade or damage the fabric. If
using tape, simply press the tape onto the back of
the channel/ track and press to affix to the wall.
Surface Mount Applications: Align the flat backside of
the channel/ track with the back side of the bracket
(for regular roll installations) or the front side of the
bracket (for reverse roll installations) If using screws,
drill 1/2” holes into the front side of the channel/ track
at equal spaces. DO NOT DRILL HOLES THROUGH
THE BACK WALL OF THE CHANNEL/TRACK. Carefully
insert the screw through the holes and secure to the
wall surface through the other side of the channel/
track (you may wish to pre-drill holes to make it
easier). Insert the color matching hole plugs into
these 1/2” holes to finish. If using tape, simply press
the tape onto the wall side of the channel/ track and
press to affix to the wall.
Surface Mount
½”
Jamb Mount
5. Installing Side Channels or Guide Track (OPTIONAL)
6. Threading the Wire
Locate the Nylon cord provided with the shade, and thread the end through the small
hole located on the wire spool. Leaving approximately 2”-3” loose, secure the cord to
the spool with a double knot at the outside of the spool. Wrap the cord around the
spool a minimum of 4 times. The direction of the wrap should mimic the direction of the
fabric and depends on whether the shade is regular roll or reverse roll.
Regular Roll
Reverse Roll
INSTALLATION INSTRUCTIONS -
™
