Wow SparkMaker SLA, Руководство по эксплуатации

Страница: 28 / 58

52
Small hex wrench
M3 long screw
Lower layer of the tank
FEP membrane
Upper layer of the tank
Insert 10 M3 long screws into the remaining holes , use a small hex wrench to tighten the
screws clockwise , so that the lower layer of the tank is tightly attached to the upper layer
of the tank , and the rubber washer is pressed tightly to tighten the FEP membrane.
＊ Notice：
❶ Do not overtighten the individual screws so that the other screws cannot be tightened. The screws
should be tightened evenly.
❷ Make sure that the lower and top layer of the tank are tightly attached so that the
FEP
membrane
is higher than the lower plane of the tank
,
and all the screw heads do not protrude to hinder the tank
installation.
53
Use a knife along the outer
edge of the tank to remove
the excess FEP membrane
and rubber washer neatly.
＊ Notice：
❶ Please use the knife carefully
to avoid accidental injury.
❷ Do not damage the
FEP
film in
the tank.
❸
Do not scratch the tank.
Outer edge of the tank
FEP membrane
knife
Get a brand new tank.
＊ Notice：
Before installing and using
,
clean the
tank with alcohol wipes to ensure that
there is no obstruction on the
FEP
film
and no resin residue on the tank.
Replace the FEP film
Replace the FEP film