Worx WXI 60, Инструкция по безопасности и эксплуатации

Страница: 11 / 16

11
WX160 WX163
Lithium-ion
cordless drill/driver
place the rotation control in the center position.
3. ReveRSIBle (See fig. c1, c2)
For drilling and screw driving use forward rotation
marked “
” (lever is moved to the left). Only use
reverse rotation marked
“
” (lever is moved to the right) to remove screws
or release a jammed drill bit.
WARNING: Never change the direction of
rotation when the chuck is rotating, wait
until it has stopped!
4. tWo-SPeeD GeAR coNtRol
(See fig. D)
The drill has a two-speed gear control designed for
drilling or driving at LO (mark is 1) or HI (mark is 2)
speeds. A slide switch is located on top of the drill to
select either LO or HI speed. When using the drill in the
LO speed range, the speed will decrease and the drill
will have greater power and torque. When using the
drill in the HI speed range, the speed will increase and
the drill will have less power and torque.
Gear I
Low speed range: for screwdriving or working with
large drilling diameter
Gear II
High speed range: for working with small drilling
diameter
WARNING: to prevent gear damage,
always allow the chuck to come to a
complete stop before changing the direction of
rotation or the two-speed gear control.
5. cHUck ADjUStMeNt (See fig. e)
To open the chuck jaws rotate the front section of
the chuck. Insert the drill bit between the chuck jaws
and rotate the front section in the opposite direction.
Ensure the drill bit is in the center of the chuck jaws.
Finally, firmly rotate the front chuck section in the
opposite directions. Your drill bit is now clamped in the
chuck.
F C1 A
B C2 G
D H
E