Worx WX687L, Руководство пользователя

Страница: 6 / 20

6
Oscillating Tool EN
TECHNICAL DATA
Type
Designation: WX687L WX687L.X
(6-designation of machinery, representative of
SoniCrafter)
WX687L WX687L.X
**
Rated voltage 120 V ~ 60 Hz
Amps 3.5 A
Oscillations speed 11000-20000/min
Oscillations angle 4°
Protection class
/II
Tool weight (without
power cable)
2.73 lbs
** X may be followed by one or two characters. All
models are the same except model number and
trademark. The suffix in models may be number from
“1” to “999” or English letter “A” to “Z” or “M1” to” M9”
which means different package or the various of
accessories packed in the package.
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Assembly and Operation
Action Figure
Mounting Accessories See Fig. A-C
Mounting the Sanding Sheet See Fig. D
Operating the On/Off Switch See Fig. E
Using the Variable Speed Dial See Fig. F
The Variable Speed Dial can be used to set the optimum
oscillating frequency according to the accessories
used and the respective application.
Oscillation
frequency
Application
High oscillation
frequency
Sanding, sawing, rasping and
polishing stone and metal.
Low oscillation
frequency
Scraping, polishing varnishes.
WORKING HINTS FOR YOUR
TOOL:
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and run
it with no load for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speeds.
Always keep the blade sharp.
Always ensure the workpiece is firmly clamped to
prevent movement.
Any movement of the material may affect the quality of
the cutting or sanding finish.
Start your tool before working and turn it off only after
you stop working.
Do not start sanding without having the sandpaper
fitted.
Do not allow the sandpaper to wear away , it will
damage the sanding pad. The guarantee does not
cover sanding pad wear and tear.
Use coarse grit paper to sand rough surfaces, medium
grit for smooth surfaces and fine grit for finishing
surfaces. If necessary, first make a test run on scrap
material.
Excessive force will reduce the working efficiency
and cause motor overload. Replacing the accessory
regularly will maintain optimum working efficiency.
MAINTAIN TOOLS WITH
CARE
Remove the plug from the socket before carrying out
any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not damage
your power tool.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
APPLICATION
WARNING:
The sawing teeth are very sharp. Do
not touch during mounting and application.
The workpiece must be clamped tightly before it is cut.
Universal Fit
TM
accessories available from Worx
Accessories work with other competitive tools.