Worx WG788, Руководство пользователя

Страница: 17 / 48

17 16
36V 19
”
Cordless lawn mower EN
17 16
operating mower. If the mower should
happen to fail despite regular maintenance,
please call our customer helpline for advice,
1-866-354-9679.
BladE SharPENiNg
KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE. A DULL BLADE DOES NOT
CUT GRASS CLEANLY OR MULCH PROPERLY.
WEAR PROPER EYE PROTECTION WHILE
REMOVING, SHARPENING, AND INSTALLING
BLADE. ENSURE THAT SAFETY KEY IS
REMOVED.
Sharpening the blade twice during a mowing
season is usually sufficient under normal
circumstances. Sand causes the blade to dull
quickly. If your lawn has sandy soil, more
frequent sharpening may be required.
REPLACE BENT OR DAMAGED BLADE
IMMEDIATELY.
whEN SharPENiNg ThE BladE:
1. Make sure blade remains balanced.
2. Sharpen blade at the original cutting angle.
3. Sharpen cutting edges on both ends of
blade to keep it balanced, removing equal
amounts of material from both ends.
To SharPEN BladE iN a ViSE (See N)
1. Be sure the switch lever is released,
the blade has stopped and the safety key
removed before removing the blade.
2. Remove blade from mower. See
instructions for removing and attaching blade.
3. Secure blade N-1 in a vise N-2.
4. Wear safety glasses and be careful not to
cut yourself.
5. Carefully file the cutting edges of the blade
with a fine tooth file N-3 or sharpening stone.
6. Check balance of blade. See instructions for
blade balancing.
7. Replace blade on mower and tighten
securely. Refer to instructions below.
BladE BalaNCiNg (See o)
Check balance of blade by placing center hole
in blade O-1 over a nail or screwdriver shank
O-2, clamped horizontally in a vise O-3. If
either
end of the blade rotates downward, file that
end. Blade is properly balanced when neither
end drops.
BladE maiNTENaNCE (See P & Q)
Renew your metal blade after 50 hours
mowing or 2 years, which ever is the sooner-
regardless of condition.
Follow these procedures to remove and
replace the blade. You will need garden
gloves (not provided) and a spanner wrench
(not provided) to remove the blade. Hold the
blade (Q-2) and unscrew the blade nut (Q-5)
counterclockwise using a spanner wrench.
Remove blade nut (Q-5), square washer (Q-4),
insulator washer (Q-3), and blade (Q-2).
To re-assemble, first position the blade
with the cutting edges towards the ground.
Assemble the components.
Ensure that the edges of the insulator washer
hook over the edge of the blade. Align the
flats on the square washer (Q-4) with the flats
on the shaft.
Then securely tighten the blade nut.
NoTE:
If the blade and insulator washer (Q-3)
are cracked or damaged, replace with new
ones.
STORAGE (See R)
Stop the mower and always remove the
safety key. Clean the exterior of the machine
thoroughly using a soft brush and cloth. Do
not use water, solvents or polishes. Remove
all grass and debris, especially from the
ventilation slots.
Turn the machine on its side and clean the
blade area. If grass cuttings are compacted
in the blade area, remove with a wooden or
plastic implement.
Store the machine in a dry place. Do not place
other objects on top of the machine.
To aid storage, press the handle height
adjustment knob, and rotate or fold the upper
handle.