Worx WG541, Руководство пользователя

Страница: 10 / 28

18V Blower/Sweeper EN
11 10 11 10
A discharged battery at normal ambient
temperature will take approximately 1 hours to
reach full charge. When charging is completed
the green light (8) will illuminate to indicate end
of charge.
Due to the different conditions, the charging
time could be slightly longer.
Note: Green = power on,
Red = charging,
Battery pack in green = charging
completed
The battery pack can then be removed for
use in your tool. The charger timer circuit and
battery pack temperature safety cut-out devices
prevent overcharge of your battery pack.
WARNING!
When battery charge runs
out after continuous use or exposure to
direct sunlight or heat, allow time for the battery
to cool down before re-charging to achieve the
full charge.
4. FITTING AND REMOVING OF
THE BATTERY
Fitting of the battery (Fig C.1)
• Align the battery as shown in fig C.1 and
simply push the battery into the housing until
it fully locks into position.
• Check that the battery is fully secured!
Removing the battery (Fig C.2)
Depress both of the battery release buttons
simultaneously while at the same time pulling
the battery out of the tool.
5. STARTING/STOPPING (Fig D)
Starting
Move the On/Off switch (2) to the “I” On
position.
Stopping
Move the On/Off switch (2) to the “O” Off
position.
WARNING!
The tool runs for a few
seconds after it has been switched off. Let
the motor come to a complete standstill before
setting the tool down.
6. USING THE BLOWER (Fig E)
The blower is intended for residential use only.
Use the blower outdoors to move debris from
hard surfaces. This blower is not designed to
clear leaves from large grassy areas, or move
wet, heavy debris.
User tips
• Hold the blow tube approx 7” above the
ground when operating the tool.
Use a sweeping motion from side to side.
Advance slowly keeping the accumulated
debris/leaves in front of you.
• After blowing the debris/leaves into a pile,
it is easy to dispose of the pile.
Caution!
• Do not blow hard objects such as nails, bolts,
or rocks.
• Do not operate the blower near bystanders
or pets.
• Use extra care when cleaning debris from
stairs or other tight areas.
• Wear safety goggles or other suitable eye
protection, long pants, and shoes.
STORAGE
WARNING: Store the blower indoors,
in a cool dry location, out of reach of
children and animals.
a) ATTACHING THE WALL
MOUNT BRACKET
Attach the wall-mount bracket to the wall with
the four screws provided.
Tighten all four screws securely. Carefully check
the bracket after mounting to make sure that no
movement can occur during use. (see F1 ).
WARNING!
Always make sure your wall-
mount bracket is securely mounted to the
wall. Failure to do so could result in an accident,
resulting in possible serious personal injury.
b) STORING YOUR BLOWER
The blower can be stored into the wall mount
bracket as illustrated (See F2).
CLEANING THE TOOL
Clean the tool regularly.
WARNING!
Keep your product dry. Under no
circumstances spray with water.
• To clean the tool, use only mild soap and a
damp cloth.