Worx WG368E, Инструкция по безопасности и эксплуатации

Страница: 18 / 24

18
Cordless Chain Saw WG368E WG368E.9
2. Inspect chain saw before and after each use. Check
saw closely if guard or other part has been damaged.
Check for any damage that may affect operator safety
or operation of saw. Check for alignment or binding of
moving parts. Check for broken or damaged parts. Do
not use chain saw if damage affects safety or operation.
Have damage repaired by authorized service center. To
locate an authorized service center, visit
www.worx.com
3. Maintain chain saw with care.
• Never expose saw to rain.
• Keep chain sharp, clean, and lubricated for better and
safer performance.
• Follow steps outlined in this manual to sharpen
chain.
• Keep handles dry, clean, and free of oil and grease.
• Keep all screws and nuts tight.
4. When servicing, use only identical replacement parts.
5. When not in use, always store chain saw
• In a high or locked place, out of children’s reach.
• In a dry place.
BAR MAINteNANce
To maximize bar life, the following bar maintenance is
recommended.
The bar rails that carry the chain should be cleaned
before storing the tool or if the bar or chain appear to be
dirty.
The rails should be cleaned every time the chain is
removed.
Turn the bar over, top rail becoming bottom and bottom
rail becoming top, around every 5 hours of use.
to cleAN tHe BAR RAIlS:
1. Remove chain cover and bar and chain. (see section
ASSEMBLY)
2. Using a wire brush, screwdriver or similar suitable
tool, clear the residue from the rails of the bar. (See
Fig. V)
3. Make sure to clean oil passages thoroughly.
coNDItIoNS WHIcH ReQUIRe GUIDe BAR
MAINteNANce:
• Saw cuts to one side or at an angle.
• Saw has to be forced through the cut.
• Inadequate supply of oil to the bar and chain.
Check the condition of the guide bar each time the chain
is sharpened. A worn guide bar will damage the chain
1
2
1/3
2/3
2
2/3
1
1/3
2 2
W
Y
Z
X
50 mm
50 mm
1
1
1
Z
Y
kg
Z
Y
a
a
K
L
M
N
O
P
Q
R
S
T
W
X
U
V