Worx SWITCHDRIVER WX176L, Быстрый старт

Страница: 12 / 13

Cordless Drill / Driver EN
12
DISPOSAL OF AN
EXHAUSTED BATTERY
PACK
Li-Ion
To preserve natural resources, please
recycle or dispose of the Battery Pack
properly. This Battery Pack contains
Lithium batteries. Consult your local waste
authority for information regarding available
recycling and/or disposal options. Discharge
your Battery Pack by operating your drill, then
remove the Battery Pack from the drill housing
and cover the Battery Pack connections with
heavy-duty adhesive tape to prevent short
circuit and energy discharge. Do not attempt
to open or remove any of the components.
TROUBLESHOOTING
1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The Forward/Reverse Rotation Control, which
is on top of the trigger, is positioned in the
lock function. Unlock the Forward/Reverse
Rotation Control by putting it into the required
rotation position. Push the trigger and the drill
will start to rotate.
2. THE DRILL STOPS BEFORE THE
SCREW IS COMPLETELY TIGHTENED.
WHY?
Verify the torque position of the Electronic
Torque-Adjusting Dial. Find the Electronic
Torque-Adjusting Dial (7) at the end of the soft
grip handle. Position 1 is the lowest torque
(screw driving force) and position 11 is the
highest torque (screw driving force). Position
is for drilling operation. Regulate the
Electronic Torque-Adjusting Dial to a higher
position to reach better result.
3. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, and having not
used a Battery Pack (8) for a prolonged time
will reduce the Battery Pack working time.
This can be corrected after several charge and
discharge operations by charging & working
with your drill. Heavy working conditions
such
as large screws into hard wood will use up the
Battery Pack energy faster than lighter working
conditions. Do not re-charge your Battery Pack
below 32° F (0
o
C) and above 113° F (45
o
C) as
this will affect performance.
4. WHY DRILL BITS CAN NOT BE
INSERTED INTO THE COLLET?
Only 1/4” hex bits will work with this collet.
We recommend that you use the dills/bits like
those supplied with your Drill N Drive.
5. WHY DOES THE DRILL NOT WORK
AFTER ROTATING THE DUAL CHUCK.
The drill can work only when the Dual Chuck is
in right position as shown in Fig. H. When the
Dual Chuck reaches proper position, you can
hear a “click” sound.
MAINTENANCE
Remove the battery pack from the tool
before carrying out any adjustment,
servicing or maintenance.
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.