10
20V Cordless Oscillating Tool
EN
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING:
To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
4. OPERATION
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The power tool is intended for sawing and remodeling
wooden materials, plastic, plaster, non-ferrous metals
and fasteners (e.g. nails) as well as for working on soft
wall tiles and for dry grinding of small surfaces. It is
especially suitable for working close to edges and for
flush cutting.
ASSEMBLY AND OPERATION
ACTION
FIGURE
Mounting Accessories
--Remove the Onboard hex wrench
See Fig. A
--Loosen the flange and insert accessories
See Fig. B1,
B2, B3
--Tighten the flange
See Fig. C
--Store the Onboard hex wrench
See Fig. D, E
Operating the On/Off Switch
See Fig. F
Using the Variable Speed Dial
See Fig. G
Remove or Install Battery Pack
See Fig.
H1,H2
LED Light
See Fig.I
The Variable Speed Dial can be used to set the
optimum oscillating frequency according to the
accessories used and the respective application.
Oscillation
frequency
Application
High oscillation
frequency:
Sanding, sawing, rasping
and polishing stone and
metal.
Low oscillation
frequency:
Scraping, polishing
varnishes.
Содержание Sonicrafter WX696
