Worx Sonicrafter WX676, Инструкция по безопасности и эксплуатации

Страница: 4 / 17

3
Oscillating tool WX676 WX676.5 WX676.7
4) PoWeR tool USe AND cARe
a) Do not force the power tool. Use
the correct power tool for your
application.
The correct power tool will
do the job better and safer at the rate for
which it was designed.
b) Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be
repaired.
c) Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories,
or storing power tools.
Such preventive
safety measures reduce the risk of starting
the power tool accidentally.
d) Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool.
Power tools are
dangerous in the hands of untrained
users.
e) Maintain power tools. check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool’s operation. If damaged,
have the power tool repaired before
use.
Many accidents are caused by poorly
maintained power tools.
f) keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
g) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed.
Use of the
power tool for operations different from
those intended could result in a hazardous
situation.
5) SeRvIce
a) Have your power tool serviced by
a qualified repair person using only
identical replacement parts.
This will
ensure that the safety of the power tool is
maintained.
b) If the replacement of the supply cord
is necessary, this has to be done
by the manufacturer or his agent in
order to avoid a safety hazard.
SAFETY INSTRUcTION FOR
cUTTING
1. Hold power tool by insulated
gripping surfaces, when performing
an operation where the cutting
accessory may contact hidden wiring
or its own cord.
Cutting accessory
contacting a “live” wire may make
exposed metal parts of the power tool
“live” and could give the operator an
electric shock.
2. Always wear a dust mask.