18
EN
NOTES
A. Before turning power on, always check Landroid is inside its working area. If not, the message “Outside working area! Press START to
reset” will be displayed. This message is also displayed when Landroid is partly but not completely inside its working area
B.If for any reason—i.e. a party, children playing...—you want to park your Landroid in the charging base: press home then OK. Landroid
will go to its base and stay there. Please note Landroid will now wait until the next scheduled mowing session. If you want to re-start it
at anytime, press start then OK to start your Landroid
C.If an error repeatedly occurs in the same area of your lawn, you might have a problem with the boundary wire so please refer to the
installation instructions and check your set up is correct with its help
D.If your lawn is divided in two separated areas, connected by a corridor less than 1m wide, one of which is not provided with the
charging base: when Landroid runs out of charge, take it manually to the charging base
E. If Landroid runs abnormally once in a while, please reset it by turning it off and removing the battery for 30 seconds, then restart it. If the
problem cannot be solved, please contact our Customer Service for help
7. TROUBLE SHOOTING
If your Landroid does not work correctly, follow the trouble shooting guide below. If the fault persists, contact Customer Service.
SYMPTOM
CAUSE
SOLUTION
The LED light on the charging
base does not turn on.
There is no power.
Check the charging base is connected properly to the charger
and the charger is connected to a suitable power supply.
Red light on the charging
base.
The boundary wire isn’t
connected.
Check that the boundary wire has been connected correctly to the
charging base. Check there are no breaks in the boundary wire.
Landroid turns on, but the
blade disc does not spin.
Landroid is searching for the
charging base.
This is normal: when Landroid needs to recharge, the blade
disc does not rotate while it is searching for the charging base
automatically.
Landroid vibrates.
The blade disc is unbalanced.
Blades may be damaged.
Check the blades and replace them if damaged.
Remove debris and foreign objects from the blades and blade
disc.
Grass is being cut
unevenly.
Landroid does not work enough
hours per day to cut the grass.
Try adding more hours to the mowing schedule.
Mowing area is too big for the
size of Landroid you have.
Try decreasing the size of the mowing area or increasing working
time.
The blades are dull and not sharp. Change all the blades and screws in order to balance the bade disc.
The cutting height is set too low
for the length of the grass.
Raise the cutting height and then gradually lower.
Grass or another object has
wrapped around the blade disc.
Check the blade disc and remove any grass or other objects that
might prevent it spinning.
There is a build-up of grass in
the blade disc or motor frame
box.
Make sure the blade disc rotates easily. If need be, you may take
off the blade disc and then remove the debris.
Battery temperature
out of range!
Please wait.
Temperature is too high (more than 55
0
C)or too low(less
than 0
0
C) when charging.
Place the charging base in a shady area or
wait until it reaches the normal temperature
Can’t find charge
station press START
to reset.
Boundary wire is beyond its maximum length (300m
or machine doesn’t have enough power to go back to
charging station.
Take Landroid to the charging station.
Mower locked!
With the ‘Lock Function’ enabled, if your Landroid does
not receive a signal from your Wi-Fi router for 3 days,
then it gets locked as a security measure.
This could be because your router lost its power or
because you changed your Wi-Fi router or network
provider.
Please reconnect Landroid to the Wi-Fi
networtk it has been originally paired with.
If this is not possible, contact Cutomer
Service.