17
EN
6. ERROR MESSAGES
Sometimes things can go wrong. Fortunately Landroid is smart enough to tell you if it is enountering an issue, so you can fix it. If in
doubt, please visit our website where you will find useful videos and further support.
MESSAGE
CAUSE
ACTION
Outside working area!
Press START to reset.
Landroid cannot find the
boundary wire signal.
1. If Landroid is actually outside of its working area: turn power off, take
Landroid inside the working area, turn the power on and press start.
2. If Landroid is inside its working area check if the LED on the charging
base is solid green. If red, check if the boundary wire is properly con-
nected to the charging base and that the base is connected to a suitable
power supply. If they are properly connected, the boundary wire terminals
are clamped incorrectly and must be reversed.
WRONG PIN! Please
retry.
PIN code is wrong.
Input the correct PIN or re-set your PIN.
Blade motor fault!
Press START to reset.
Blade disc is blocked by an
object, e.g. a branch.
Turn power off.
Turn Landroid upside down and check if there’s anything preventing the
blade disc from rotating and remove any obstruction.
Turn Landroid upright.
Turn power on. Press start
Blade is over-loaded by
thick dense grass.
Turn power off.
Take Landroid to an area with short grass or adjust the cutting height to a
higher setting.
Turn power on. Press start.
Wheels motor fault!
Press START to reset.
Wheel motor is blocked in
some way.
Turn power off and take Landroid to an area free from obstacles.
Turn power on. Press start.
If the error message is still displayed, turn power off. Turn Landroid
upside-down and check if there’s anything preventing the wheels from
rotating.
Remove any obstruction, turn Landroid upright, turn power on.
Upside down! Press
START to reset.
This could have happened
when Landroid came into
contact with a sloping
surface which made it
overturn.
Turn Landroid upright and remove any obstacle that might have caused
Landroid to overturn.
Mower trapped! Press
START to reset.
Landroid is trapped.
Turn power off.
Take Landroid to an area of your lawn free of obstacles, then turn power
on. Press start.
If the error message is still displayed: turn power off, turn Landroid
upside-down. Check if there is anything preventing the wheels from
rotating.
Remove any obstruction, turn the Landroid upright, turn power on.
Mower lifted! Press
START to reset.
Landroid is lifted up.
Turn power off.
Take Landroid to an area clear of obstacles, turn power on. Press start.
If the error message is still displayed: turn power off, turn Landroid
upside-down and check there’s anything that can cause Landroid to be
lifted up.
Remove any possible object, turn Landroid upright, turn power on.
Battery voltage too
low! Please change
battery.
Battery exausted.
In this case you must turn Landroid off and place it in the charging base,
then ‘Emergency charging’ will be displayed and it will start charging.
If the battery error still persist, your battery is damaged and need to be
changed.
Wire missing! Press
START to reset.
Machine can’t find
boundary wire signal.
If the LED light is red, check if the boundary wire is well connected to the
clamps on the charging base.
If the problem persists, check that the boundary wire hasn’t been cut.